Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE
Accelerator Pedal: Installation
- Place accelerator pedal assembly over mounting studs protruding from floor pan. See Fig 1. Tighten retaining nuts to 12 N.m (105 in. lbs.) torque.
- Place cable through slot in top of pedal shaft. See Fig 2.
- While holding pedal lever. Push retainer clip forward in vehicle engaging it into the pedal lever. See Fig 3.
- Hold the throttle body lever in the wide open position and install the throttle cable. See Fig 4.
- Before starting engine, operate accelerator pedal to check for any binding.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.