2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE

Overhead Console: Installation

  1. Position the overhead console in the vehicle.
  2. Connect the electronic module and the reading/courtesy lamps electrical connector.
  3. Position the overhead console and install the overhead console retaining screw, located in the storage bin. Torque the screw to 1.2 N.m (10 in. lbs.).
  4. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.