Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE
Overhead Console: Disassembly
- Remove the overhead console from the vehicle (Refer to ELECTRICAL/OVERHEAD CONSOLE - REMOVAL)Β .
- Remove the two module retaining screws. See Fig 1.
1 - Overhead Console Housing 2 - CMTC Module Retaining Screws 3 - Module Electrical Connector 4 - CMTC Module - Disconnect the module electrical connector. Depress the connector retaining tab and pull straight apart.
- Remove the module from the overhead console.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
