2005 Chrysler Pacifica LimitedFACTORY OEM SERVICE PROCEDURE

Knock Sensor: Installation: 3.8L

Fig 1: KNOCK SENSOR - 3.8L
GC0002375Courtesy of DAIMLERCHRYSLER CORP.
1 - KNOCK SENSOR
  1. Install knock sensor. Tighten knock sensor to 20 N.m (15.2 in. lbs.) torque (1). See Fig 1. Over or under tightening effects knock sensor performance, possibly causing improper spark control.Β 
  2. Route the knock sensor wire in the proper location. See Fig 1.
  3. Connect the electrical connector.
  4. Lower vehicle.
  5. Connect the negative battery cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.