Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler Pacifica Base, 3.8 LFACTORY OEM SERVICE PROCEDURE
Ignition Control: Specifications: Torque
| DESCRIPTION | N.m | Ft. Lbs. | In. Lbs. |
|---|---|---|---|
| SKREEM Module Screws | 1.8 | - | 16 |
| Ignition Switch Mounting Nuts | 3.4 | - | 30 |
| Spark Plug 3.5l | 28 | 20 | - |
| Spark Plug 3.8L | 17.5 | 13 | - |
| Ignition Coils 3.5L | 6.7 | - | 60 |
| Ignition Coil Nuts 3.8L | 11.8 | - | 105 |
| Camshaft Position Sensor Bolt 3.5L | 12 | - | 106 |
| Camshaft Position Sensor Bolt 3.8L | 14.1 | - | 125 |
| Knock Sensor 3.5L | 20 | 15.2 | - |
| Knock Sensor 3.8L | 10 | 7 | - |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.