2005 Chrysler PT Cruiser GT, 4D Wagon, StandardFACTORY OEM SERVICE PROCEDURE

Sentry Key Immobilizer Module: Installation

NOTE: If the SKIM is replaced with a new unit, a DRB lll® scan tool MUST be used to initialize the new SKIM and to program at least two Sentry Key transponders (Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES/SENTRY KEY IMMOBILIZER MODULE - STANDARD PROCEDURE) .
  1. Place the SKIM into position.
  2. Rotate the SKIM and its mounting bracket downwards and then to the side towards the steering column. See Figure.
  3. Install the two screws securing the SKIM to the top of the steering column. See Figure.
  4. Engage the steering column wire harness to the Sentry Key Immobilizer Module (SKIM). See Figure.
  5. Install the steering column upper and lower shrouds. Refer to SHROUD - UPPER/LOWER .
  6. Install the Lower Instrument Panel Cover. Refer to INTERIOR/EXTERIOR .
  7. Connect the battery negative cable.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.