Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler PT Cruiser Base, 2D Convertible, StandardFACTORY OEM SERVICE PROCEDURE
Occupant Restraint Controller: Installation
- Connect ORC connector and ensure that the connector and all locking tabs are engaged.CAUTION: USE SUPPLIED NUTS ONLY
- Position ORC (arrow pointing forward) in the console floor bracket, replace ground eyelet, and attach the nuts and tighten to 9.6 to 14 N.m (85 to 125 in. lbs.) torque. See Figure.NOTE: Place the ground eyelet over the front (towards the front of the vehicle) weld stud when reattaching the ORC.
- Install center console assembly.WARNING: DO NOT CONNECT BATTERY NEGATIVE CABLE YET (Refer to ELECTRICAL/RESTRAINTS - DIAGNOSIS AND TESTING - AIRBAG SYSTEM) .
- Close hood.
- Verify vehicle and system operation.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.