Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler PT Cruiser Base, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
Removal - 1/2 Downstream
The downstream heated oxygen sensor threads into the exhaust pipe behind the catalytic convertor. See Fig 1.
| 1 - DOWN STREAM O2 SENSOR |
| 2 - UP STREAM O2 SENSOR |
- Remove the air cleaner lid and makeup air hose.
- Remove the negative battery cable.
- Raise vehicle and support.
- Disconnect electrical connector from sensor.
- Disconnect sensor electrical harness from clips along body.
- Remove sensor using an oxygen sensor crow foot wrench such as Snap-On tool YA8875 or equivalent. See Fig 2.
| 1 - DOWNSTREAM HEATED OXYGEN SENSOR |
| 2 - CATALYTIC CONVERTOR |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.