Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler Crossfire Limited, 2D Convertible, AutomaticFACTORY OEM SERVICE PROCEDURE
On/Off Switch Indicator Module: Removal
- Disconnect the negative battery cable (2). Wait two minutes for the system capacitor to discharge before further service.
- Unsnap and remove the carpeted floor mat.
- Untuck the carpeting in the passenger footwell, and fold the carpet down to expose the foam insulation.
- Remove the foam insulating panel.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.