Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2005CROSSFIRE LIMITED, 2D CONVERTIBLE, AUTOMATICREPAIR AND DIAGNOSISENGINE PERFORMANCESYSTEMDTCS P0174 TO P0302
2005 Chrysler Crossfire Limited, 2D Convertible, Automatic
DTCS P0174 To P0302
2005 Chrysler Crossfire Limited, 2D Convertible, AutomaticSECTION DTCS P0174 To P0302
- Diagnosis And Testing
- (P0174) Fuel System 2/1 Lean Control Below Limit (At Load)
- (P0174) Fuel System 2/1 UNDERCORRECTION Of Fuel Mixture (Off Idle)
- (P0175) Fuel System 2/1 OVERCORRECTION Of Fuel Mixture (Off Idle)
- (P0175) Fuel System 2/1 Lean Control Below Limit (At Idle)
- (P0200) Fuel Injector Circuit
- (P0201) Fuel Injector #1 Circuit
- (P0202) Fuel Injector #2 Circuit
- (P0203) Fuel Injector #3 Circuit
- (P0204) Fuel Injector #4 Circuit
- (P0205) Fuel Injector #5 Circuit
- (P0206) Fuel Injector #6 Circuit
- (P0211) Throttle Actuator Stuck
- (P0221) Apps Sensor 1 And 2 Voltage Correlation
- (P0221) Idle Speed Performance
- (P0221) Electronic Throttle Control Module Performance
- (P0221) Electronic Throttle Control Module Processor
- (P0222) Apps Signal 2 Circuit Low
- (P0223) Apps Signal 2 Circuit High
- (P023A) Charge Air Cooler Circulation Pump Control Circuit
- (P023B) Charge Air Cooler Circulation Pump Circuit Low
- (P023C) Charge Air Cooler Circulation Pump Circuit High
- (P0300) Multiple Cylinder Misfire
- (P0301) Cylinder #1 Misfire
- (P0302) Cylinder #2 Misfire
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.