2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Steering Column Control Module: Assembly

Fig 1: MULTIFUNC FROM CIRCUIT BOARD
GC0013246Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the Steering Column Control Module (SCCM) circuit board onto the multi-function switch.
    Fig 2: MULTIFUNC REAR
    GC0013252Courtesy of DAIMLERCHRYSLER CORP.
  2. Install the multi-function switch and circuit board and tighten the three screws (1) from the bottom of the SCCM.
    Fig 3: SCCM STALKS
    GC0013245Courtesy of DAIMLERCHRYSLER CORP.
  3. Install the steering column telescoping lever (3).
    Fig 4: SPEED CONTROL FROM SCCM
    GC0013251Courtesy of DAIMLERCHRYSLER CORP.
  4. Install the speed control switch (1).
    Fig 5: STRUT UNDEDER ESP
    GC0013249Courtesy of DAIMLERCHRYSLER CORP.
  5. If equipped with manual telescoping column  Install the strut (1).
    Fig 6: SCCM STALKS
    GC0013245Courtesy of DAIMLERCHRYSLER CORP.
  6. If equipped with electronic telescoping column  , install the electric tilt lever and switch (3).
    Fig 7: STEERING ANGLE SENSOR SCREW
    GC0013248Courtesy of DAIMLERCHRYSLER CORP.
  7. If equipped wit ESP  Install the steering angle sensor and screw (3) located at the six o'clock position.
    Fig 8: CLOCKSPRING SCREWS
    GC0013247Courtesy of DAIMLERCHRYSLER CORP.
  8. Install the clockspring and screws (1).
  9. If equipped with ESP  Recalibrate the steering angle sensor using the scan tool.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.