Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Driver Airbag Trim Cover: Installation
- Place the driver airbag into new driver airbag trim cover. Be careful not to pinch the airbag cushion between the latch hook mounting plate and the trim cover.NOTE: Make sure that the horn switch wire harness is routed through the cut-out on the side of the trim cover and positioned in the hook on the back of the housing. Attach connector to the housing.
- Push down on the latch hook mounting plate and guide the latch hooks into the slots on the driver airbag cover.
- Once all the latch hooks have been started, pull the driver airbag cover away from the driver airbag to fully seat the latch hooks.
- Install the driver airbag (2) (Refer to ELECTRICAL/RESTRAINTS/DRIVER AIRBAG - INSTALLATION)Β . Torque the two screws (1) to 10 N.m (89 in. lbs.).
WARNING:
Do not connect the battery negative cable (Refer to ELECTRICAL DIAGNOSTICS - 300 & MAGNUM
. Personal injury or death may result if the system test is not performed first.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
