Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
DTCS B210E To U0141
- Diagnosis And Testing
- B210E-Battery Voltage High
- B212C-Ignition Run/Start Input Circuit Open
- B212D-Ignition Run Only Input Circuit Open
- B2201-Calibration Mismatch
- B2205-Original VIN Missing/Mismatch
- B2206-Current VIN Missing/Mismatch
- B2207-Occupant Restraint Controller Internal 1
- B2208-Occupant Restraint Controller Internal 2
- B2209-Occupant Restraint Controller Internal 3
- B220A-Occupant Restraint Controller Internal 4
- B220B-Occupant Restraint Controller Firing Stored Energy
- B220C-Occupant Restraint Controller Accelerometer 1 Internal
- B220D-Occupant Restraint Controller Accelerometer 2 Internal
- B220F-Occupant Restraint Controller Control Driver 1
- B2210-Occupant Restraint Controller Control Driver 2
- B2212-Occupant Classification Module Internal
- B223B-Vehicle Configuration Mismatch
- B223D-Occupant Classification Module DTC Present
- U0019-Can B Bus
- U0020-Can B Bus Off Performance
- U0022-Can B Bus (+) Circuit Low
- U0023-Can B Bus (+) Circuit High
- U0026-Can B Bus (-) Circuit High
- U0121-Lost Communication With Anti-Lock Brake System (Abs) Control Module
- U0141-Lost Communication With Front Control Module
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
