Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Memory Positions In Driver's Door Switch
WARNING: This page is about a different car, the 2002 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Turn the ignition switch to the ON position.
- Press memory button number 1 if you are setting the memory for driver number 1 or number 2 if you are setting the memory for driver number 2.
- Use the seat, mirror and adjustable pedal switches to adjust the seat, recliner, side view mirrors and adjustable pedals to the desired positions.
- Set the radio station presets (up to 10 AM and 10 FM stations can be set).
- Turn the ignition switch to the OFF position and remove the key.
- Press and release the SET (S) button located on the driver's door. A chime will sound telling you that you are in the set memory mode. You have 5 seconds after the chime to complete the next step.
- Within 5 seconds, press and release button 1 or 2 on the driver's door. A chime will sound signaling you that the driver memory has been set. A message will be displayed in the overhead console indicating a position has been set.
- Within 5 seconds, press and release the LOCK button on the Remote Keyless Entry Transmitters. A chime will sound signaling you that the transmitter has been successfully linked.
NOTE:
Each time the SET (S) button and a numbered button are pressed, you erase the old memory and store a new one.
Repeat the above steps for the second position using the other driver's door numbered button and Remote Keyless Entry Transmitter.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.