Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Memory Selector Switch
Remove memory selector switch. See MEMORY SELECTOR SWITCH under REMOVAL & INSTALLATION. Check resistance of switch when pressing buttons. See MEMORY SELECTOR SWITCH RESISTANCE table. If continuity is not as specified, replace switch.
| Switch Position | (1) Ohms | ||
|---|---|---|---|
| "1" | 6507.5-7192.5 | ||
| "2" | 1995-2205 | ||
| "S" | 4265.5-4714.5 | ||
| Released | 23,417.5-25,882.5 | ||
|
|||
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.