Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
ATC Module Messages Not Received
WARNING: This page is about a different car, the 2002 Dodge Grand Caravan, 2002 Dodge Caravan, 2002 Chrysler Voyager, and 2002 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Turn ignition on. Using scan tool, select BODY then AUTOMATIC TEMP CONTROL. If scan tool communicates with ATC, go to next step. If scan tool does not communicate with ATC, go to BUS +/- SIGNALS OPEN OR NO RESPONSE FROM HVAC .
- Using scan tool, erase DTCs. Turn ignition off and on. Wait a minimum of one minute. Using scan tool, check for DTCs. If DTC resets, replace Body Control Module (BCM). See BODY CONTROL MODULE under REMOVAL & INSTALLATION. If DTC does not reset, testing is complete.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.