Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Sliding Door Control Module: Installation
WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
- Position the control module and install the retaining screw.
- Connect the control module electrical connectors. Slide the locking tab into the locked position.
- Install the appropriate door trim panel on the vehicle. Refer to TRIM PANEL for the procedure.
- Install the weather shield. Refer to SLIDING DOOR WEATHERSTRIP for the procedure.
- Connect the negative battery cable.
- Using an appropriate scan tool, check and erase any power door control module diagnostic trouble codes.
- Verify power door system operation. Cycle the power door through one complete open and close cycle.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.