2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Removal - SBEC Controller

WARNING: This page is about a different car, the 2004 Dodge Grand Caravan, 2004 Dodge Caravan, and 2004 Chrysler Town & Country. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect the negative battery cable.
  2. Remove the battery shield.
  3. Remove the 2 upper PCM bracket bolts (Fig 1).
    Fig 1: Identifying PCM Attaching Bolts
    G02676620Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove the 2 PCM connectors.
  5. Remove the headlamp, refer to the HEADLAMP for more information.
  6. Remove the lower PCM mounting bolt (Fig 2).
    Fig 2: Locating PCM Lower Bolt
    G02676621Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove PCM.
Chapter Navigation
Return to Chapter: Removal
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.