Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Ignition System (Service Information): Cylinder-Key/Lock: Removal
- Disconnect the negative battery cable.
- Remove bezel ignition switch ring.
- Pull center console bezel loose from instrument panel. See Fig 1.
- Insert ignition key and turn to the "ON" position.
- Depress the locking tab on the ignition switch housing. See Fig 2.
- Pull the key cylinder from the ignition switch housing. See Fig 3.
| 1 - Locking Tab Location |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.