Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Ignition System (Service Information): Coil-Ignition: Removal: 5.7L
Before removing or disconnecting any spark plug cables, note their original position. Remove cables one-at-a-time. To prevent ignition crossfire, spark plug cables MUSTÂ be placed in cable tray (routing loom) into their original position.
An individual ignition coil (1) is used at each cylinder. The coil mounts to the top of the valve cover with two bolts (2). The bottom of the coil is equipped with a rubber boot (3) to seal the spark plug to the coil. Inside each rubber boot is a spring. The spring is used for a mechanical contact between the coil and the top of the spark plug.
- Depending on which coil is being removed, the throttle body air intake tube or intake box may need to be removed to gain access to coil.
- Unlock electrical connector (4) by moving slide lock (1) first. Press on release lock (3) while pulling electrical connector from coil.
- Disconnect secondary high-voltage cable (2) from coil with a twisting action.
- Clean area at base of coil with compressed air before removal.
- Remove two mounting bolts (6) (note that mounting bolts are retained to coil).
- Carefully pull up coil from cylinder head opening with a slight twisting action.
- Remove coil from vehicle.
- Before installing spark plug cables to either the spark plugs or coils, or before installing a coil to a spark plug, apply dielectric grease to inside of boots.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
