2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Sensor-Manifold Absolute Pressure: Removal: 3.5L

Fig 1: MAP LOCATION
GC0013141Courtesy of DAIMLERCHRYSLER CORP.
  1. Sensor location.
  2. Disconnect negative battery cable.
    Fig 2: ELECTRICAL CONNECTOR
    GC0013145Courtesy of DAIMLERCHRYSLER CORP.
  3. Unlock the electrical connector.
    Fig 3: ELECTRICAL CONNECTOR
    GC0013142Courtesy of DAIMLERCHRYSLER CORP.
  4. Disconnect the electrical connector.
    Fig 4: 1/4 TURN TO REMOVE/INSTALL
    GC0013143Courtesy of DAIMLERCHRYSLER CORP.
  5. Rotate sensor 1/4 turn clockwise.
  6. Pull up on sensor.
    Fig 5: MAP SENSOR REMOVED
    GC0013144Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove sensor.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.