2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Sensor-Manifold Absolute Pressure: Installation: 5.7L

Fig 1: MAP SENSOR LOCATION 5.7L
GC0013147Courtesy of DAIMLERCHRYSLER CORP.
  1. Clean MAP sensor mounting hole at intake manifold.
  2. Check MAP sensor o-ring seal for cuts or tears.
  3. Position sensor (3) into intake manifold.
  4. Rotate sensor 1/4 turn clockwise for installation.
  5. Connect electrical connector (2) to sensor (3).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.