2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Electrical Component Locator: Grounds

GROUNDS LOCATION

Component Location
G100 At left front of engine compartment. See Figure .
G101 At right front of engine compartment. See Figure .
G102 At right side of engine compartment. See Figure .
G104 (2.7L) On right side of engine. See Figure .
G104 (3.5L) On right side of engine. See Figure .
G104 (5.7L) On right side of engine. See Figure .
G105 (2.7L & 3.5L) On rear of engine.
G105 (5.7L) On rear of engine. See Figure .
G106 (2.7L) On left side of engine. See Figure .
G106 (3.5L) On left side of engine. See Figure .
G106 (5.7L) On rear of engine. See Figure .
G107 (3.5L) On right side of engine, near generator.
G108 (3.5L) On left side of engine. See Figure .
G200 Behind left side of dash. See Figure .
G201 Behind right side of dash. See Figure .
G202 Behind left side of dash. See Figure .
G300 Below left "B" pillar. See Figure .
G301 Below right "B" pillar. See Figure .
G302 On right front of cargo pan. See Figure .
G303 On right rear cargo pan. See Figure .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.