2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Charging System: Generator: Removal: 5.7L

WARNING: DISCONNECT NEGATIVE CABLE FROM BATTERY BEFORE REMOVING BATTERY OUTPUT WIRE (B+ WIRE) FROM GENERATOR. FAILURE TO DO SO CAN RESULT IN INJURY OR DAMAGE TO ELECTRICAL SYSTEM.
  1. Disconnect negative battery cable at battery.
  2. Remove generator drive belt. Refer to COOLING for procedure.
  3. Raise and support vehicle.
  4. Unsnap plastic insulator cap from B+ output terminal.
  5. Remove B+ terminal mounting nut at rear of generator. Disconnect terminal from generator.
  6. Disconnect field wire connector at rear of generator by pushing on connector tab.
    Fig 1: GENERATOR SUPPORT BRACKET
    GC0015639Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove generator support bracket nut (4) and bolt (3). Remove support bracket (1).
    Fig 2: GENERATOR
    GC0015638Courtesy of DAIMLERCHRYSLER CORP.
  8. Remove 2 generator mounting bolts (1).
  9. Remove generator (2) from vehicle.
Chapter Navigation
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.