2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE

Battery Tray: Installation

Fig 1: Removing/Installing Battery Tray
GC0015627Courtesy of DAIMLERCHRYSLER CORP.
  1. Position the battery tray in the vehicle and install the mounting fasteners.
    Fig 2: Removing/Installing Power Distribution Center
    GC0015626Courtesy of DAIMLERCHRYSLER CORP.
  2. Position the Power Distribution Center (PDC) onto the battery tray mounting tabs. Gently apply downward pressure on the PDC until it snaps into place.
  3. Install the battery, (Refer to ELECTRICAL/BATTERY SYSTEM/BATTERY - INSTALLATION)Β .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.