Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2005 Chrysler 300 BaseFACTORY OEM SERVICE PROCEDURE
Sentry Key Remote Entry Module: Installation
When a PCM and the SKREEM are replaced at the same time, perform the following steps in order:
- Program the new PCM.
- Program the new SKREEM.
- Replace all ignition keys and program them to the new SKREEM.
(Refer to ELECTRICAL/ELECTRONIC CONTROL MODULES - STANDARD PROCEDURE - PCM/SKREEM PROGRAMMING)
- Position the SKREEM on the ignition lock housing and install the retaining screw (1).
- Position the ignition switch/lock assembly (3) up in behind the instrument panel and push rearward.
- Install the two mounting nuts to the front of the instrument panel (1).
- From underneath the ignition switch/lock assembly, tighten the lower retaining screw (3).
- Reach up behind the left side of the center stack and connect the ignition switch (6) and SKREEM (5) electrical connectors.
- Install the cluster bezel (Refer to BODY/INSTRUMENT PANEL/CLUSTER BEZEL - REMOVAL) .
- Install the steering column opening cover (Refer to BODY/INSTRUMENT PANEL/STEERING COLUMN OPENING COVER - INSTALLATION) .
- Connect the battery negative cable.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
