2004 Chrysler Pacifica AWDFACTORY OEM SERVICE PROCEDURE

Battery Cables: Installation

  1. Position the battery cable in the vehicle.
  2. One at a time, trace and install the battery cable, retaining fasteners and routing clips until the desired cable is properly installed in the engine wire harness assembly.
  3. Install the tape on the engine wire harness assembly.
  4. Connect the positive battery cable terminal. Torque to 40 in. lbs.
  5. Connect the negative battery cable terminal. Torque to 40 in. lbs.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.