The quick learn procedure requires the use of the DRBIII® scan tool. This program allows the PCM/TCM to recalibrate itself. This will provide the best possible transaxle operation.

NOTE: The quick learn procedure should be performed if any of the following procedures are performed:

Transaxle Assembly Replacement
Powertrain/Transmission Control Module Replacement
Solenoid/Pressure Switch Assembly Replacement
Clutch Plate and/or Seal Replacement
Valve Body Replacement or Recondition

To perform the Quick Learn Procedure, the following conditions must be met:

The brakes must be applied
The engine speed must be above 500 rpm
The throttle angle (TPS) must be less than 3 degrees
The shift lever position must stay until prompted to shift to overdrive
The shift lever position must stay in overdrive after the Shift to Overdrive prompt until the DRBIII® indicates the procedure is complete
The calculated oil temperature must be above 60° and below 200°

Plug the DRBIII® scan tool into the diagnostic connector. The connector is located under the instrument panel.
Go to the Transmission screen .
Go to the Miscellaneous screen .
Select Quick Learn Procedure. Follow the instructions of the DRBIII® to perform the Quick Learn Procedure.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

• You smell fuel, burning insulation, or see smoke.

• Brakes feel soft, pull hard to one side, or make grinding noises.

• The engine overheats, stalls repeatedly, or misfires under load.

• You are missing required tools, torque specs, or safe lifting equipment.

• You are not confident in the next step or safety outcome.

Safety Warning

Standard Procedure - Quick Learn Procedure

Use the Manual With the Right Hardware

When to See a Mechanic