2004 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Transmission Shift Schedules

The PCM is programmed to allow it to select a variety of shift schedules. Shift schedule selection is dependent on the following:

  • Shift lever position
  • Throttle position
  • Engine load
  • Fluid temperature
  • Software calibration level

As driving conditions change, the PCM appropriately adjusts the shift schedule. Refer to the following chart to determine the appropriate operation expected, depending on driving conditions.

Fig 1: Identifying Driving Condition Chart
G01856989Courtesy of DAIMLERCHRYSLER CORP.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.