Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE
General Service Specifications
COOLING SYSTEM SPECIFICATIONS
| Application | Specification | ||
|---|---|---|---|
| Concorde, Intrepid & 300M | |||
| Coolant Replacement Interval | 100, 000 Miles Or 60 Months | ||
| Coolant Capacity | |||
| 2.7L | 10.5 Qts. (10.5L) | ||
| 3.5L | 11.0 Qts. (10.5L) | ||
| Pressure Cap | 14-18 psi (.98-1.27 KG/CM2 ) | ||
| Thermostat | |||
| Starts To Open | 180°F (82°C) | ||
| Fully Opens | 203°F (95°C) | ||
THERMOSTAT R & I
Refer to ENGINE COOLANT THERMOSTAT - 2.7L or ENGINE COOLANT THERMOSTAT - 3.5L .
WATER PUMP R & I
Refer to WATER PUMP - 2.7L or WATER PUMP - 3.5L .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.