Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE
Electrical Component Locator: Motors
MOTORS LOCATION
| Component | Location |
|---|---|
| Blend Door Actuator | On lower left side of HVAC assembly. See Figure. |
| Driver/Passenger Door Lock Motor | In rear of respective driver/passenger door. See Figure. |
| Driver/Passenger Power Seat Front Riser Motor | In respective seat. |
| Driver/Passenger Power Seat Horizontal Motor | In respective seat. |
| Driver/Passenger Power Seat Rear Riser Motor | In respective seat. |
| Driver/Passenger Power Seat Recliner Motor | In respective seat. |
| Front Washer Pump Motor | On washer reservoir. See Figure. |
| Front Wiper Motor | On left side of firewall, under tower to tower (crossbar) support. See Figure. |
| Fuel Pump Module | In top of fuel tank. |
| Headlamp Washer Pump Motor | Near left headlamp. |
| Idle Air Control Motor (2.7L) | On throttle body. See Figure. |
| Idle Air Control Motor (3.5L) | On throttle body. |
| Leak Detection Pump | On fuel tank, on EVAP canister upper bracket. |
| Left Headlamp Leveling Motor | Behind left headlamp. See Figure. |
| Left/Right Rear Door Lock Motor | At rear of respective rear door. |
| Mode Door Actuator | On lower left side of HVAC assembly. See Figure. |
| Radiator Fan Motor (Base 2.7L) | At rear of fan. |
| Radiator Fan Motor No. 1 (Except Base 2.7L) | At rear of fan motor. |
| Radiator Fan Motor No. 2 (Except Base 2.7L) | At rear of fan motor. |
| Recirculation Door Actuator | On right side of HVAC assembly. See Figure. |
| Right Headlamp Leveling Motor | Behind right headlamp. See Figure. |
| Starter Motor (2.7L) | At left rear of engine. See Figure. |
| Starter Motor (3.5L) | At left rear of engine. See Figure. |
| Sun Roof Motor | At rear of sun roof frame assembly. |
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.