Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
Battery System: Battery: Removal
The battery is accessible without removing the right front wheel and tire assembly.
- Verify that the ignition switch and all accessories are OFF.
- Turn the steering wheel to the full right position.
- Disconnect and isolate the negative battery cable remote terminal from the remote battery post.WARNING: NEVER GET UNDER A LIFTED VEHICLE IF NOT SUPPORTED PROPERLY ON SAFETY STANDS.
- Remove the air cleaner housing. Refer to the ENGINE 3.5L .
- Remove battery splash shield.
- Disconnect the heater blanket cord, if equipped.
- Remove the two short bolts from the battery hold down and remove the hold down.
- Disconnect the positive battery cable from the battery.
- Slide the battery toward rear of vehicle.
- Disconnect the negative battery cable from the battery.
- Remove battery from vehicle.
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
No obligation. See pricing before you book.