Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE
Battery HOLDDOWN: Removal
- Verify that the ignition switch and all accessories are OFF.
- Turn the steering wheel to the full right position.
- Disconnect and isolate the negative battery cable remote terminal from the remote battery post.
- Remove the air cleaner housing. Refer to ENGINE 3.5L .
- Remove battery splash shield.
- Remove the two short bolts from the battery hold down and remove the hold down.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.