Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE
Battery Cables: Removal
- Turn the ignition switch to the Off position. Be certain that all electrical accessories are turned off.
- Disconnect and isolate the remote battery negative cable terminal.
- Remove the battery from the vehicle. Refer to BATTERY .
- One at a time, trace the battery cable retaining pushpins, fasteners and routing clips until the cables are free from the vehicle.
- Remove the battery cables from the engine compartment.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.