Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Intrepid (CANADA) V6-2.7LFACTORY OEM SERVICE PROCEDURE
Power Steering Fluid
Wipe off the power steering fluid reservoir so that it is free of dirt. Check the fill level of the fluid in the reservoir according to the markings on the side of the reservoir. Measure the MAX, COLD/MIN, COLD fluid levels when the fluid is at normal ambient temperature, approximately 32�C to 43�C (90�F to 110�F). Add fluid as necessary and do not overfill. Use only Mopar ATF+4 Automatic Transmission Fluid in this power steering system.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.