Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004CROSSFIRE STANDARDREPAIR AND DIAGNOSISENGINE PERFORMANCEFUEL DELIVERYFUEL SYSTEMTHROTTLE BODYINSTALLATION
2004 Chrysler Crossfire Standard
Throttle Body: Installation
2004 Chrysler Crossfire StandardSECTION Installation
- Install the new O-ring (2) to the throttle body (5).
- Install the throttle body (5) to the intake. Tighten to 9 N.m (80 in lbs.).
- Connect the throttle body harness connector (3).
- Install the crankcase vent tube (1) to the intake.
- Install the MAF sensor. See MANIFOLD AIR FLOW (MAF) SENSOR .
- Install the air cleaner housing. See 3.2L V6 article.
- Connect the negative battery cable.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.