Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2004CROSSFIRE STANDARDREPAIR AND DIAGNOSISENGINE MECHANICALFUEL SYSTEMACCELERATOR PEDALREMOVAL
2004 Chrysler Crossfire Standard
Accelerator Pedal: Removal
2004 Chrysler Crossfire StandardSECTION Removal
- Disconnect the negative battery cable.
- Remove the accelerator pedal upper nut (1).
- Remove the lower accelerator nut cover (1) and the nut.
- Lift the accelerator pedal off of the welded stud and out of the bracket.
- Disconnect the accelerator pedal harness connector from the accelerator pedal.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.