2004 Chrysler Crossfire AutomaticFACTORY OEM SERVICE PROCEDURE

Service Specifications

MANUAL A/C SERVICE SPECIFICATIONS

Application Specification
Compressor Type Nippondenso
Compressor Belt Tension Non-Adjustable
System Oil Capacity (1) 4.4 ozs. (.13L)
Refrigerant R-134a Capacity 1.97 Lbs. (.89 kg)
System Operating Pressures (2)
  High Side 200-280 psi (1380-1930 kPa)
  Low Side 38-42 psi (262-290 kPa)
(1) Use ND-8 PAG refrigerant oil.
(2) With temperature at 80°F (27°C) with 80% humidity. The discharge air temperatures will be lower if the humidity is less than the specified percentages shown.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.