2004 Chrysler Crossfire AutomaticFACTORY OEM SERVICE PROCEDURE

Lateral Acceleration Sensor: Operation

The lateral acceleration sensor measures the amount of lateral acceleration during cornering. This sensor uses a spring/mass type element to measure the amount of lateral acceleration. The lateral acceleration that occurs during cornering causes the spring/mass element to move from its normal position to a position corresponding to the magnitude of the lateral acceleration. Every change in the spring/mass element position changes the output voltage of the sensor.

Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.