Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2004 Chrysler Crossfire AutomaticFACTORY OEM SERVICE PROCEDURE
General Service Specifications: Specifications
COOLING SYSTEM SPECIFICATIONS
| Application | Specification | |||
|---|---|---|---|---|
| Coolant Replacement Interval | 100, 000 Miles Or 60 Months | |||
| Coolant Capacity | 11.8 Qts. (11.2L) | |||
| Pressure Cap | 14-18 psi (.98-1.27 kg/cm2 ) | |||
| Thermostat | ||||
| Starts To Open | 195°F (90°C) | |||
| Fully Opens | (1) | |||
|
||||
THERMOSTAT R & I
Refer to ENGINE COOLANT THERMOSTAT .
WATER PUMP R & I
Refer to WATER PUMP .
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.