Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
Radiator Fan Relay Output: Testing
- Turn ignition off. Disconnect radiator fan relay connector. Radiator fan relay is located near driver's side frame rail. See Fig 1 . Connect a jumper wire between Orange/Red and Dark Blue/Dark Green wires at radiator fan relay harness connector. If one or both radiator fans is not operating, go to next step. If both radiator fans operate, no problem is indicated at this time. Test is complete.
- Disconnect jumper wire. Disconnect radiator fan connectors. Measure voltage between ground and Black/Dark Green wire at each radiator fan. If both resistance readings are less than 5 ohms, go to next step. If one or both resistance readings is 5 ohms or more, repair open in appropriate Black/Dark Green wire between radiator fan relay and ground connection. Ground connection is located near left headlight.
- Connect a jumper wire between Orange/Red and Dark Blue/Dark Green wires at radiator fan relay harness connector. Measure voltage between ground and Dark Blue/Dark Green wire at each radiator fan. If both voltage readings are more than 10 volts, replace radiator fans. If one or both voltage readings is 5 ohms or less, repair open in appropriate Dark Blue/Dark Green wire between radiator fan and radiator fan relay.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
