Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler Voyager Base, 2.4 BFACTORY OEM SERVICE PROCEDURE
A/C Clutch Relay Output: Testing
- Ensure A/C system is properly charged with refrigerant. Turn ignition on. Using scan tool, actuate A/C clutch relay. Listen for clicking sound at A/C clutch relay. The A/C clutch relay is located in Integrated Power Module (IPM). IPM is located on left side of engine compartment, next to battery. See Figure and Figure . If clicking sound is not heard at A/C clutch relay, go to next step. If clicking sound is heard at A/C clutch relay, no problem is indicated at this time. Test is complete.
- Turn ignition off. Disconnect A/C clutch connector. Measure resistance between ground and Black/Gray wire at A/C clutch harness connector. See Fig 2 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Black/Gray wire between A/C clutch and ground connection. Ground connection is located above starter.
- Turn ignition on. Using scan tool, actuate the A/C clutch relay. Measure voltage between ground and Dark Blue/Yellow wire at A/C clutch harness connector. If voltage is 11 volts or less, go to next step. If voltage is more than 11 volts, replace A/C clutch.
- Turn ignition off. Using a test light connected to ground, probe terminal No. 30 at A/C clutch relay socket in IPM. See Figure . If test light illuminates, go to next step. If test light does not illuminate, check fuse No. 18 (15-amp) in IPM. If fuse is blown, check for cause of fuse to blow. Repair as necessary and replace fuse. If fuse is okay, replace IPM.
- Turn ignition off. Disconnect IPM C3 connector. See Fig 1 . Measure resistance of Dark Blue/Yellow wire between A/C clutch harness connector and terminal No. 7 at IPM C3 harness connector. See Fig 2 and Fig 3 . If resistance is less than 5 ohms, go to next step. If resistance is 5 ohms or more, repair open in Dark Blue/Yellow wire.
- Reconnect IPM C3 harness connector. Measure resistance of Dark Blue/Yellow wire between terminal No. 87 at A/C clutch relay socket in IPM and A/C clutch harness connector. If resistance is less than 5 ohms, replace A/C clutch relay. If resistance is 5 ohms or more, replace IPM.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- β’ You smell fuel, burning insulation, or see smoke.
- β’ Brakes feel soft, pull hard to one side, or make grinding noises.
- β’ The engine overheats, stalls repeatedly, or misfires under load.
- β’ You are missing required tools, torque specs, or safe lifting equipment.
- β’ You are not confident in the next step or safety outcome.
