Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler PT Cruiser Dream Cruiser, AutomaticFACTORY OEM SERVICE PROCEDURE
Diagnostic Trouble Code Definitions
DIAGNOSTIC TROUBLE CODE MESSAGES & CODES
| Generic Scan Tool Code (1) | DRBIII® Scan Tool Message | ||||||
|---|---|---|---|---|---|---|---|
| P0016 | CRANKSHAFT/CAMSHAFT TIMING MISALIGNMENT | ||||||
| P0031 | O2 SENSOR 1/1 HEATER CIRCUIT LOW | ||||||
| P0032 | O2 SENSOR 1/1 HEATER CIRCUIT HIGH | ||||||
| P0033 | SURGE VALVE SOLENOID CIRCUIT | ||||||
| P0037 | O2 SENSOR 1/2 HEATER CIRCUIT LOW | ||||||
| P0038 | O2 SENSOR 1/2 HEATER CIRCUIT HIGH | ||||||
| P0068 | MANIFOLD PRESSURE/THROTTLE POSITION CORRELATION - HIGH FLOW/VACUUM LEAK | ||||||
| P0070 | AMBIENT TEMP SENSOR STUCK | ||||||
| P0071 | AMBIENT TEMP SENSOR PERFORMANCE | ||||||
| P0072 | AMBIENT TEMP SENSOR LOW | ||||||
| P0073 | AMBIENT TEMP SENSOR HIGH | ||||||
| P0106 | MAP SENSOR PERFORMANCE | ||||||
| P0107 | MAP SENSOR LOW | ||||||
| P0108 | MAP SENSOR HIGH | ||||||
| P0110 | INTAKE AIR TEMP SENSOR STUCK | ||||||
| P0111 | INTAKE AIR TEMP SENSOR PERFORMANCE | ||||||
| P0112 | INTAKE AIR TEMP SENSOR LOW | ||||||
| P0113 | INTAKE AIR TEMP SENSOR HIGH | ||||||
| P0116 | ENGINE COOLANT TEMPERATURE SENSOR PERFORMANCE | ||||||
| P0117 | ENGINE COOLANT TEMPERATURE SENSOR LOW | ||||||
| P0118 | ECT SENSOR VOLTAGE TOO HIGH | ||||||
| P0121 | THROTTLE POSITION SENSOR VOLTAGE DOES NOT AGREE WITH MAP | ||||||
| P0122 | THROTTLE POSITION SENSOR #1 LOW | ||||||
| P0123 | THROTTLE POSITION SENSOR #1 HIGH | ||||||
| P0124 (2) | THROTTLE POSITION SENSOR/APPS INTERMITTENT | ||||||
| P0125 | INSUFFICIENT COOLANT TEMP FOR CLOSED-LOOP FUEL CONTROL | ||||||
| P0128 | THERMOSTAT RATIONALITY | ||||||
| P0129 | BAROMETRIC PRESSURE OUT-OF-RANGE LOW | ||||||
| P0131 | O2 SENSOR 1/1 VOLTAGE LOW | ||||||
| P0132 | O2 SENSOR 1/1 VOLTAGE HIGH | ||||||
| P0133 | O2 SENSOR 1/1 SLOW RESPONSE | ||||||
| P0135 | O2 SENSOR 1/1 HEATER PERFORMANCE | ||||||
| P0137 | O2 SENSOR 1/2 VOLTAGE LOW | ||||||
| P0138 | O2 SENSOR 1/2 VOLTAGE HIGH | ||||||
| P0139 | O2 SENSOR 1/2 SLOW RESPONSE | ||||||
| P0141 | O2 SENSOR 1/2 HEATER PERFORMANCE | ||||||
| P0171 | FUEL SYSTEM 1/1 LEAN | ||||||
| P0172 | FUEL SYSTEM 1/1 RICH | ||||||
| P0201 | FUEL INJECTOR #1 | ||||||
| P0202 | FUEL INJECTOR #2 | ||||||
| P0203 | FUEL INJECTOR #3 | ||||||
| P0204 | FUEL INJECTOR #4 | ||||||
| P0218 (2) | HIGH TEMPERATURE OPERATION ACTIVATED | ||||||
| P0234 | OVERBOOST PERFORMANCE | ||||||
| P0243 | WASTEGATE SOLENOID CIRCUIT | ||||||
| P0300 | MULTIPLE CYLINDER MISFIRE | ||||||
| P0301 | CYLINDER #1 MISFIRE | ||||||
| P0302 | CYLINDER #2 MISFIRE | ||||||
| P0303 | CYLINDER #3 MISFIRE | ||||||
| P0304 | CYLINDER #4 MISFIRE | ||||||
| P0315 | NO CRANK SENSOR LEARNED | ||||||
| P0325 | KNOCK SENSOR #1 CIRCUIT | ||||||
| P0335 | CRANKSHAFT POSITION SENSOR CIRCUIT | ||||||
| P0339 | CRANKSHAFT POSITION SENSOR INTERMITTENT | ||||||
| P0340 | CAMSHAFT POSITION SENSOR CIRCUIT | ||||||
| P0344 | CAMSHAFT POSITION SENSOR INTERMITTENT | ||||||
| P0351 | IGNITION COIL #1 CIRCUIT | ||||||
| P0352 | IGNITION COIL #2 CIRCUIT | ||||||
| P0420 | CATALYTIC 1/1 EFFICIENCY | ||||||
| P0440 | GENERAL EVAP SYSTEM FAILURE | ||||||
| P0441 | EVAP PURGE SYSTEM PERFORMANCE | ||||||
| P0442 | EVAP SYSTEM MEDIUM LEAK DTC | ||||||
| P0443 | EVAP PURGE SOLENOID CIRCUIT | ||||||
| P0452 | NVLD PRESSURE SWITCH SENSE CIRCUIT LOW | ||||||
| P0453 | NVLD PRESSURE SWITCH SENSE CIRCUIT HIGH | ||||||
| P0455 | EVAP SYSTEM LARGE LEAK DTC | ||||||
| P0456 | EVAP SYSTEM SMALL LEAK | ||||||
| P0461 | FUEL LEVEL SENSOR #1 PERFORMANCE | ||||||
| P0462 | FUEL LEVEL SENSOR #1 LOW | ||||||
| P0463 | FUEL LEVEL SENSOR #1 HIGH | ||||||
| P0480 | LOW SPEED FAN CONTROL RELAY CIRCUIT | ||||||
| P0480 | LOW SPEED FAN CONTROL RELAY CIRCUIT (TURBO ONLY) | ||||||
| P0481 | HIGH SPEED FAN CONTROL RELAY CIRCUIT | ||||||
| P0498 | NVLD CANISTER VENT VALVE SOLENOID CIRCUIT LOW | ||||||
| P0499 | NVLD CANISTER VENT VALVE SOLENOID CIRCUIT HIGH | ||||||
| P0501 | VEHICLE SPEED SENSOR #1 PERFORMANCE (AUTO TRANS) | ||||||
| P0501 | VEHICLE SPEED SENSOR #1 PERFORMANCE (MANUAL TRANS) | ||||||
| P0508 | IAC VALVE SENSE CIRCUIT LOW | ||||||
| P0509 | IAC VALVE SENSE CIRCUIT HIGH | ||||||
| P0513 | INVALID SKIM KEY | ||||||
| P0516 | BATTERY TEMPERATURE SENSOR LOW | ||||||
| P0517 | BATTERY TEMPERATURE SENSOR HIGH | ||||||
| P0519 | IDLE SPEED PERFORMANCE | ||||||
| P0522 | OIL PRESSURE SENSOR LOW | ||||||
| P0532 | A/C PRESSURE SENSOR LOW | ||||||
| P0533 | A/C PRESSURE SENSOR HIGH | ||||||
| P0551 | POWER STEERING SWITCH PERFORMANCE | ||||||
| P0562 | BATTERY VOLTAGE LOW | ||||||
| P0563 | BATTERY VOLTAGE HIGH | ||||||
| P0579 | SPEED CONTROL SWITCH #1 PERFORMANCE | ||||||
| P0580 | SPEED CONTROL SWITCH #1 LOW | ||||||
| P0581 | SPEED CONTROL SWITCH #1 HIGH | ||||||
| P0582 | SPEED CONTROL VAC SOLENOID CIRCUIT | ||||||
| P0586 | SPEED CONTROL VENT SOLENOID CIRCUIT | ||||||
| P0594 | SPEED CONTROL SERVO POWER CIRCUIT | ||||||
| P0600 | SERIAL COMMUNICATION LINK | ||||||
| P0601 | INTERNAL MEMORY CHECKSUM INVALID | ||||||
| P0604 (2) | INTERNAL TCM | ||||||
| P0605 (2) | INTERNAL TCM | ||||||
| P0613 (2) | INTERNAL TCM | ||||||
| P0622 (3) | GENERATOR FIELD CONTROL CIRCUIT | ||||||
| P0627 | FUEL PUMP RELAY CIRCUIT | ||||||
| P0630 | VIN NOT PROGRAMMED IN PCM | ||||||
| P0632 | ODOMETER NOT PROGRAMMED IN PCM | ||||||
| P0633 | SKIM KEY NOT PROGRAMMED IN PCM | ||||||
| P0645 | A/C CLUTCH RELAY CKT | ||||||
| P0685 | ASD RELAY CONTROL CIRCUIT | ||||||
| P0688 | ASD RELAY SENSE CIRCUIT LOW | ||||||
| P0700 | TRANSMISSION CONTROL SYSTEM/READ TRANSMISSION DTCS ON THE DRBIII® SCAN TOOL | ||||||
| P0703 | BRAKE SWITCH #2 CIRCUIT | ||||||
| P0706 (2) | CHECK SIGNAL SHIFTER | ||||||
| P0711 (2) | TRANSMISSION TEMPERATURE SENSOR PERFORMANCE | ||||||
| P0712 (2) | TRANSMISSION TEMPERATURE SENSOR LOW | ||||||
| P0713 (2) | TRANSMISSION TEMPERATURE SENSOR HIGH | ||||||
| P0714 (2) | TRANSMISSION TEMPERATURE SENSOR INTERMITTENT | ||||||
| P0715 (2) | INPUT SPEED SENSOR ERROR | ||||||
| P0720 (2) | OUTPUT SPEED SENSOR ERROR | ||||||
| P0725 (2) | ENGINE SPEED SENSOR CIRCUIT | ||||||
| P0731 (2) | GEAR RATIO ERROR IN 1ST | ||||||
| P0732 (2) | GEAR RATIO ERROR IN 2ND | ||||||
| P0733 (2) | GEAR RATIO ERROR IN 3RD | ||||||
| P0734 (2) | GEAR RATIO ERROR IN 4TH | ||||||
| P0736 (2) | GEAR RATIO ERROR IN REVERSE | ||||||
| P0740 (2) | TORQUE CONVERTER CLUTCH CONTROL CIRCUIT | ||||||
| P0750 (2) | LR SOLENOID CIRCUIT | ||||||
| P0755 (2) | 2/4 SOLENOID CIRCUIT | ||||||
| P0760 (2) | OD SOLENOID CIRCUIT | ||||||
| P0765 (2) | UD SOLENOID CIRCUIT | ||||||
| P0833 | CLUTCH RELEASED SWITCH CIRCUIT | ||||||
| P0841 (2) | LR PRESSURE SWITCH SENSE CIRCUIT | ||||||
| P0845 (2) | 2/4 HYDRAULIC PRESSURE TEST FAILURE | ||||||
| P0846 (2) | 2/4 PRESSURE SWITCH SENSE CIRCUIT | ||||||
| P0850 | PARK/NEUTRAL SWITCH PERFORMANCE | ||||||
| P0870 (2) | OD HYDRAULIC PRESSURE TEST FAILURE | ||||||
| P0871 (2) | OD PRESSURE SWITCH SENSE CIRCUIT | ||||||
| P0884 (2) | POWER UP AT SPEED | ||||||
| P0888 (2) | RELAY OUTPUT ALWAYS OFF | ||||||
| P0890 (2) | SWITCHED BATTERY | ||||||
| P0891 (2) | TRANSMISSION RLY ALWAYS ON | ||||||
| P0897 (2) | WORN OUT/BURNT TRANSAXLE FLUID | ||||||
| P0944 (2) | LOSS OF PRIME | ||||||
| P0952 (2) | AUTOSTICK INPUT CIRCUIT LOW | ||||||
| P0992 (2) | 2-4/OD HYDRAULIC PRESSURE TEST FAILURE | ||||||
| P1105 | TIP SENSOR SOLENOID PERFORMANCE | ||||||
| P1106 | BARO SOLENOID PERFORMANCE | ||||||
| P1188 | TIP SENSOR PERFORMANCE | ||||||
| P1189 | TIP SENSOR CIRCUIT LOW | ||||||
| P1190 | TIP SENSOR CIRCUIT HIGH | ||||||
| P1602 | PCM NOT PROGRAMMED | ||||||
| P1603 | PCM INTERNAL DUAL-PORT RAM COMMUNICATION | ||||||
| P1604 | PCM INTERNAL DUAL-PORT RAM READ/WRITE INTEGRITY FAILURE | ||||||
| P1607 | PCM INTERNAL SHUTDOWN TIMER RATIONALITY | ||||||
| P1652 (2) | SERIAL COMMUNICATION LINK MALFUNCTION | ||||||
| P1681 | NO FUEL LEVEL BUS MESSAGE | ||||||
| P1684 (2) | BATTERY WAS DISCONNECTED | ||||||
| P1686 | NO SKIM BUS MESSAGE | ||||||
| P1687 | NO CLUSTER BUS MESSAGE | ||||||
| P1694 (2) | BUS COMMUNICATION WITH ENGINE MODULE | ||||||
| P1696 | EEPROM MEMORY WRITE DENIED/INVALID | ||||||
| P1697 | EMR (SRI) MILE NOT STORED | ||||||
| P1698 | NO TRANSMISSION BUS MESSAGE | ||||||
| P1775 (2) | SOLENOID SWITCH VALVE LATCHED IN TCC POSITION | ||||||
| P1776 (2) | SOLENOID SWITCH VALVE LATCHED IN LR POSITION | ||||||
| P1790 (2) | FAULT IMMEDIATELY AFTER START | ||||||
| P1793 (2) | TRD LINK COMMUNICATION ERROR | ||||||
| P1794 (2) | SPEED SENSOR GROUND ERROR | ||||||
| P1797 (2) | MANUAL SHIFT OVERHEAT | ||||||
| P1854 | TIP BARO OUT OF RANGE | ||||||
| P2302 | IGNITION COIL #1 SECONDARY CIRCUIT-INSUFFICIENT IONIZATION | ||||||
| P2305 | IGNITION COIL #2 SECONDARY CIRCUIT-INSUFFICIENT IONIZATION | ||||||
| P2503 | CHARGING SYSTEM VOLTAGE LOW | ||||||
|
|||||||
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
Rather have a pro handle this?
A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.
Comes to youSame-day available12-month warranty
Get a Free QuoteNo obligation. See pricing before you book.