2003 Chrysler PT Cruiser Base, AutomaticFACTORY OEM SERVICE PROCEDURE

Transmission Control Module: Removal

NOTE: If the transmission control module (TCM) is being replaced with a new or replacement unit, the Pinion Factor and Quick Learn procedures must be performed. (Refer to STANDARD PROCEDURE - PINION FACTOR SETTINGΒ  ) (Refer to STANDARD PROCEDURE - QUICK LEARN PROCEDUREΒ  )
  1. Disconnect battery negative cable.
  2. Raise vehicle on hoist.
  3. Remove left front wheel/tire assembly (Fig. Fig 1 ).
    Fig 1: Removing And Installing Wheel/Tire
    G02663537Courtesy of DAIMLERCHRYSLER CORP.
  4. Remove wheel house splash shield.
  5. Remove TCM 60-way connector.
  6. Remove three TCM bracket-to-body mounting screws (Fig. Fig 2 ).
    Fig 2: Removing And Installing TCM
    G02663538Courtesy of DAIMLERCHRYSLER CORP.
  7. Remove TCM from bracket (Fig. Fig 2 ).
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.