Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
SYS.OK|MANUAL.DB● LIVE
HOMESERVICE MANUALSCHRYSLER2003INTREPID SXTREPAIR AND DIAGNOSISTRANSMISSIONAUTOMATIC TRANSOVERHAUL - AUTOMATIC TRANSMISSIONTRANSMISSION RANGE SENSORINSTALLATION
2003 Chrysler Intrepid SXT
Transmission Range Sensor: Installation
2003 Chrysler Intrepid SXTSECTION Installation
- Install the TRS to the manual shaft. Make sure TRS locating pin rests in manual valve bore slot.
- Install the TRS/manual shaft retaining screw and torque to 5 N.m (45 in. lbs.) torque. See Figure.
- Install the manual shaft seal. See Figure.
- Install valve body to transaxle. Refer to INSTALLATION .
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.