Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
System Test
2003 Chrysler Intrepid SXTSECTION System Test
A test of the Tire Pressure Monitoring System can be initiated in the EVIC. The test sequence is as follows:
- Scroll to the blank display by pressing the STEP button.
- Press and hold the RESET button for five seconds.
- The EVIC will emit a beep to indicate the start of the test.
- The EVIC will clear the sensor signal counters
- The vehicle icon will be displayed with transmission counters at each corner. (Same display as for pressures but with counters in place of pressures.)
- Drive the vehicle at speeds above 40 km/h (25 mph) for 10 minutes.
- The counters will increase by one each time a sensor signal is received by the EVIC (approximately 1/min from each wheel except the spare).
- The test will continue until any EVIC button is pressed or until the ignition is cycled to OFF.
RENDER: 1.0x
NO RELATED
Recommended Tools & Savings
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Affiliate disclosure: We may earn a commission at no extra cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.