2003 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE

DTC P1602: Pcm Not Programmed: Testing

  1. Ignition on, engine not running. With the DRBIII® scan tool, erase DTCs. With the DRBIII® scan tool program the PCM. Start the engine. Allow the engine to reach normal operating temperature. With the DRBIII® scan tool, read DTCs. Does the DTC reset? If yes, go to next step. If no, the PCM has been successfully programmed. Test is complete.
  2. The ignition switch must be left in the off position for a minimum of 10 seconds. Cycle the ignition switch to the off position and then back to run. Attempt to program the PCM. Start the vehicle and allow it to reach normal operating temperatures. With the DRBIII® scan tool, read DTCs. Does the DTC reset? If yes, replace and program the PCM. See PROGRAMMING . If no, the PCM has been successfully programmed into the PCM. Test is complete.
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

Shop Manual-Ready ToolsCompare Repair QuoteQuote Shield Pro

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.

Rather have a pro handle this?

A certified mobile mechanic comes to your home or office. They bring the tools, you stay comfortable. No tow truck, no waiting room, no surprises.

Comes to youSame-day available12-month warranty
Get a Free Quote

No obligation. See pricing before you book.