Safety Warning
DIY auto repair can cause serious injury, fire, or vehicle damage. These guides are for informational purposes only. Always follow OEM torque specs, wear PPE, and consult a certified mechanic if you are unsure. You are solely responsible for your safety.
2003 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE
DTC P0581: Speed Control Switch #1 High: Testing
- Do not press any of the speed control switch buttons. Ignition on, engine not running. With the DRBIII® scan tool, read the speed control voltage. Is the speed control voltage above 4.8 volts? If yes, go to next step. If no, see INTERMITTENT CONDITION under SELF-DIAGNOSTIC SYSTEM.
- Turn the ignition off. Remove the speed control switches from the steering wheel. Measure the resistance across each speed control switch. Monitor the ohmmeter while pressing each function button on each switch. Resume/Accel (15,400 ohms), Cancel (900-918 ohms), Decel (Coast) (2910-2970 ohms), On/Off (0 ohm), Set (6584-6716 ohms). Does the function on the speed control switches have the correct ohm value? If yes, go to next step. If no, replace the speed control switch that had the incorrect resistance value.
- Turn the ignition off. Disconnect the speed control On/Off switch harness connector. Disconnect the speed control Resume/Accel switch harness connector. Disconnect the PCM harness connectors. Measure the voltage of the (V37) S/C switch signal circuit at the speed control harness connector. Is the is the voltage above 5.0 volts? If yes, repair the (V37) S/C switch signal circuit shorted to the battery voltage. If no, go to next step.
- The measurement must be taken from both speed control switch harness connector. Turn the ignition off. Disconnect the speed control On/Off switch harness connector. Disconnect the speed control Resume/Accel Switch harness connector. Disconnect the PCM harness connectors. Measure the resistance of the (K4) sensor ground circuit from the speed control harness connector to the appropriate terminal of Miller Special Tool (8815). Is the resistance below 5.0 ohms for both measurements? If yes, Using the wiring diagram as a guide, inspect the wire harness and connectors. Visually inspect the related wire harness. Look for any chafed, pierced, pinched, or partially broken wires. Visually inspect both the component and the PCM connectors. Pay particular attention to all power and ground circuits. If there are no possible causes remaining, replace and program the PCM. See PROGRAMMING . If no, repair the (K4) sensor ground circuit for an open.
CAUTION:
Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool (8815) to perform diagnosis.
Factory Service Tools
Use the Manual With the Right Hardware
Pair factory procedures with proven DIY tools so the instructions are easier to execute.
Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.
When to See a Mechanic
Stop DIY work and contact a certified mechanic immediately if any of the following apply:
- • You smell fuel, burning insulation, or see smoke.
- • Brakes feel soft, pull hard to one side, or make grinding noises.
- • The engine overheats, stalls repeatedly, or misfires under load.
- • You are missing required tools, torque specs, or safe lifting equipment.
- • You are not confident in the next step or safety outcome.
