2003 Chrysler Intrepid SXTFACTORY OEM SERVICE PROCEDURE

DTC P0113: Intake Air Temperature Sensor High: Testing

  1. Ignition on, engine not running. With the DRBIII® scan tool, read the IAT sensor voltage. Is the voltage above 4.6 volts? If yes, go to next step. If no, see INTERMITTENT CONDITION  under SELF-DIAGNOSTIC SYSTEM.
  2. Turn the ignition off. Disconnect the IAT sensor harness connector. Ignition on, engine not running. Measure the voltage of the (K21) IAT signal circuit in the IAT sensor harness connector. Is the voltage above 5.2 volts? If yes, repair the short to battery voltage in the (K21) IAT signal circuit. If no, go to next step.
  3. Turn the ignition off. Disconnect the IAT harness connector. Connect a jumper wire between the (K21) IAT signal circuit and the (K4) sensor ground circuit in the IAT harness connector. Ignition on, engine not running. With the DRBIII® scan tool, read IAT voltage. Is the voltage below 1.0 volt? If yes, replace the IAT sensor. If no, go to next step.
  4. CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool (8815) to perform diagnosis.
  5. Turn the ignition off. Disconnect the IAT sensor harness connector. Disconnect the PCM harness connectors. Measure the resistance of the (K21) IAT signal circuit from the IAT sensor harness connector to the appropriate terminal of Miller Special Tool (8815). Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the open in the (K21) IAT signal circuit.
  6. CAUTION: Do not probe the PCM harness connectors. Probing the PCM harness connectors will damage the PCM terminals resulting in poor terminal to pin connection. Install Miller Special Tool (8815) to perform diagnosis.
  7. Turn the ignition off. Disconnect the IAT sensor harness connector. Disconnect the PCM harness connectors. Measure the resistance of the (K4) sensor ground circuit from the IAT sensor harness connector to the appropriate terminal of Miller Special Tool (8815). Is the resistance below 5.0 ohms? If yes, go to next step. If no, repair the open in the (K4) sensor ground circuit.
  8. Using the wiring diagram as a guide, inspect the wire harness and connectors. Pay particular attention to all power and ground circuits. If there are no possible causes remaining, replace and program the PCM. See PROGRAMMING .
Factory Service Tools

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Disclosure: Verified tool recommendations may earn an affiliate commission at no cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • • You smell fuel, burning insulation, or see smoke.
  • • Brakes feel soft, pull hard to one side, or make grinding noises.
  • • The engine overheats, stalls repeatedly, or misfires under load.
  • • You are missing required tools, torque specs, or safe lifting equipment.
  • • You are not confident in the next step or safety outcome.