Fuel System Pressure Release

2003 Chrysler Intrepid SXTSECTION Fuel System Pressure Release
WARNING: Fuel system is under high pressure. Release fuel pressure before disconnecting any fuel lines or fuel system components.
  1. Turn ignition off. Remove fuel pump relay from Power Distribution Center (PDC). PDC is located in engine compartment. Start engine and let it idle until engine stalls. Attempt restarting engine until engine will no longer run. Turn ignition off. Remove fuel tank filler cap from fuel tank to release any pressure from fuel tank.
  2. Fuel system components may now be serviced. Use care when servicing fuel system components, as some fuel pressure may still exist in the fuel system. Install fuel tank filler cap and fuel pump relay once fuel system components are serviced.
  3. Diagnostic Trouble Code (DTC) may have been stored in PCM due to the removal of fuel pump relay. Clear DTCs from PCM. Using scan tool, clear DTCs.
RENDER: 1.0x

NO RELATED

Recommended Tools & Savings

Use the Manual With the Right Hardware

Pair factory procedures with proven DIY tools so the instructions are easier to execute.

Affiliate disclosure: We may earn a commission at no extra cost to you.

When to See a Mechanic

Stop DIY work and contact a certified mechanic immediately if any of the following apply:

  • β€’ You smell fuel, burning insulation, or see smoke.
  • β€’ Brakes feel soft, pull hard to one side, or make grinding noises.
  • β€’ The engine overheats, stalls repeatedly, or misfires under load.
  • β€’ You are missing required tools, torque specs, or safe lifting equipment.
  • β€’ You are not confident in the next step or safety outcome.